Baby Mirror for a Tesla Model Y, 3, S or X: How to Fit One on a Fixed Headrest

You buy a baby car mirror, buckle it on, and by the first corner it's pointing at the ceiling. If you drive a Tesla, that isn't bad luck. It's a mismatch between how most mirrors hold on and how your rear seats are built.

Why Strap Mirrors Struggle in a Tesla

Most baby car mirrors hold on with buckle straps. One goes around the headrest, and the other runs over the top and back under the headrest, through the gap above the seat. On a seat where the headrest slides up and down on two posts, that gap is there, and the strap grips.

Teslas, like some other cars, have headrests molded into the seat (Leo&Ella's spec for the Tesla mirror says "fixed headrests, like most Teslas"). There are no posts and no gap. The strap has nowhere to go, so the mirror hangs from one strap and shifts every time the car moves.

Strap mirror

Elastic loop

Slide to compare Strap mirror and Elastic loop

How the Elastic Loop Works

The Leo&Ella Tesla baby car mirror skips the straps. It uses a patent-pending continuous elastic loop, with no straps and no Velcro. The loop stretches over the headrest like a sleeve and holds it all the way around, so it doesn't need a gap to thread through. The back of the mirror has a non-slip silicone backing, which keeps it from sliding against the seat.

It arrives fully assembled, and the mirror itself is 11.5" x 7.5" of convex, shatterproof ABS acrylic in a matte black finish.

Model Y, Model 3, Model S and Model X

Leo&Ella lists the Tesla mirror for the Model 3, Model Y, Model S and Model X, and the fit works the same way on all four: one loop, over the headrest, nothing to thread. Because it's an elastic loop rather than a seat-specific bracket, it also fits adjustable headrests. That makes it the easy pick if you swap the mirror between a Tesla and another car.

Fitting It in Four Steps

1. Slide the loop over the headrest. Stretch the elastic loop over the top of the headrest, as if you were putting on a sleeve.
2. Settle the mirror. Pull it down until the mirror sits flat against the back of the headrest, facing the rear-facing seat.
3. Aim it from the driver's seat. With your baby in the car seat, sit where you drive and rotate the mirror until your baby's face appears in your rearview mirror. It rotates 360°, so small changes are easy.
4. Give it a tug. Hold the mirror and wiggle it. It shouldn't slide or sag.

The whole job takes under 10 seconds.

Using It Well

A mirror is for quick glances, the same way you'd check your side mirrors, not for watching your baby. If you want a closer look at night, the Camio camera monitor adds a 5" Full HD screen with infrared night vision. We compare the two in Baby Car Mirror vs. Camera Monitor.

Each mirror also comes with a free car window sunshade 2-pack while supplies last, which helps with side-window sun in the back seat. It may ship separately.

Quick Answers

Will it fit my Tesla Model Y? Yes. The Tesla & Fixed mirror is listed for the Model 3, Model Y, Model S and Model X.

Do I need tools? No. It arrives fully assembled and fits by hand in under 10 seconds.

Is the glass safe? It's convex ABS acrylic, not glass, and it's shatterproof.

Can I use it in another car? Yes. The loop fits fixed headrests and adjustable ones, including in sedans, SUVs and trucks.

Ready to fit yours? Shop the Tesla baby car mirror.